Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: I-PAC 2 firmware upgrade issue  (Read 375 times)

0 Members and 1 Guest are viewing this topic.

roy6585

  • Trade Count: (0)
  • Jr. Member
  • **
  • Offline Offline
  • Posts: 3
  • Last login:January 30, 2024, 02:36:13 pm
  • I want to build my own arcade controls!
I-PAC 2 firmware upgrade issue
« on: January 30, 2024, 08:31:00 am »
Hello, 

I'm hoping someone can advise me on how to correct my firmware upgrade issue. 


I have a post 2015 ipac 2 (I believe this to be a post 2015 because of the mini usb connector on bottom of board). It is currently on firmware 1.44. I would like to upgrade the firmware to multimode so I can switch the board to x-input. 


I have downloaded the firmware from the Ultimak site. When I run winpac2 and start the firmware upgrade, my board goes into resetting mode, then the secondary program pops up to select firmware , but my board is not detected again. Not sure why after resetting the board, it is no longer detected by my PC.

Any info would be greatly appreciated.


Thanks,

Roy 

Logged
Pages: [1]
  
Go Up
« previous next »