Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: How to Properly Configure Daytona 3 USA Controls in Teknoparrot?  (Read 560 times)

0 Members and 1 Guest are viewing this topic.

Ali

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 14
  • Last login:March 23, 2024, 05:13:06 pm
  • I want to build my own arcade controls!
How to Properly Configure Daytona 3 USA Controls in Teknoparrot?
« on: August 09, 2023, 03:54:06 pm »
I can run Daytona 3 Championship USA (2017) and the updated Daytona Championship USA (2017) New Season under Terknoparrot...
But the joystick control is VERY Bad! Itīs extremely sensitive!
Ok, the game was developed to use a wheel...
But, is there any tip to improve it?
Is it general question or only specific problem with Daytona 3 using Teknoparrot?
Best regards....
« Last Edit: August 19, 2023, 02:51:55 pm by Ali »
Logged
Pages: [1]
  
Go Up
« previous next »