I have a G07 Electrohome chassis I've been working on. when I received it, it had a new cap kit and new flyback installed. B+ is high and reads 167v. on one side of large resistor, just a couple volts lower on other side and doesn't get warm. I used a 60w. light bulb trick connected between Ground and TP91. The bulb lights slightly but the good news is I can now adjust the B+ to 120v. I can now assume the Power supply is working properly. I removed X701 and the light bulb and without the bulb the B+ goes high(167v.).I'm stumped what to do now. I know there's a horiz. deflection problem. One other question, can I operate this chassis without the yoke connected? Any ideas as to where to go from here would be appreciated. Thanks guys