Author Topic: CRT Emudriver issues with TV. (Read 1435 times)

Osirus23 · « **on:** October 04, 2020, 03:00:02 pm »

Trying to setup GroovyMAME and CRT Emudriver on a 15kHz TV using composite sync. I am using an HD6450. I managed to get a stable image on the TV after enabling EDID on Analog_0, enabling composite sync, and generating and installing modes. After a restart though, the picture on the CRT was out of sync again. It didn't come back until I ran vmmaker and installed modes again. Does this really need to be done after each restart? Surely something is messed up. I would also lose my stable image on the CRT if I ever disconnected the LCD monitor from the DisplayPort connector and Windows switched the CRT to be the primary display.

Osirus23 · « **Reply #1 on:** October 05, 2020, 05:42:40 pm »

Is this related to the DISPLAY# changing all the time? I'm trying to set everything up with a portable LCD connected via DP on digital_0 then disconnect it and just use the CRT on analog_0 once its ready.


Main	Restorations	Software	Audio/Jukebox/MP3	Everything Else	Buy/Sell/Trade
Project Announcements	Monitor/Video	GroovyMAME	Merit/JVL Touchscreen	Meet Up	Retail Vendors
Driving & Racing	Woodworking	Software Support Forums	Consoles	Project Arcade	Reviews
Automated Projects	Artwork	Frontend Support Forums	Pinball	Forum Discussion	Old Boards
Raspberry Pi & Dev Board	controls.dat	Linux	Miscellaneous Arcade	Wiki Discussion	Old Archives
Lightguns	Arcade1Up	Try the site in https mode		Site News


Unread posts \| New Replies \| Recent posts \| Rules \| Chatroom \| Wiki \| File Repository \| RSS \| Submit news

Author Topic: CRT Emudriver issues with TV. (Read 1435 times)

Osirus23

CRT Emudriver issues with TV.

Osirus23

Re: CRT Emudriver issues with TV.