Author Topic: Newbie HAPP 3" Trackball setup (Read 912 times)

Wzrd0803 · « **on:** March 25, 2020, 07:42:37 pm »

I was given a Happ trackball by bobbyb13 (Thank you so much!). It has a six pin Molex connector and green boards.

If I get an Optiwiz 3 and the GGG no solder cable, is that all I need for my arcade cabinet with MAME to use the trackball?

PL1 · « **Reply #1 on:** March 25, 2020, 10:45:38 pm »

Quote from: Wzrd0803 on March 25, 2020, 07:42:37 pm

I was given a Happ trackball by bobbyb13 (Thank you so much!). It has a six pin Molex connector and green boards.

If I get an Optiwiz 3 and the GGG no solder cable, is that all I need for my arcade cabinet with MAME to use the trackball?

Yes, but you might want to upgrade to red boards, too.

According to the Happ Trackball FAQ, pinouts are the same for the old green boards (A052-1010-00) as the new red boards. (A052-1011-00)

Quote

What are the pinouts of the Optic Sensor pcb A052-1010-00 and A052-1011-00 used on the trackball or trackwheel or 360 steering wheel ?
These alll use the same Item # A052-1011-00 Optic Sensor Board. The connections are as follows.
Pin 1 - Output A
Pin 2 - +5V
Pin 3 - GND
Pin 4 - Output B

Scott


Main	Restorations	Software	Audio/Jukebox/MP3	Everything Else	Buy/Sell/Trade
Project Announcements	Monitor/Video	GroovyMAME	Merit/JVL Touchscreen	Meet Up	Retail Vendors
Driving & Racing	Woodworking	Software Support Forums	Consoles	Project Arcade	Reviews
Automated Projects	Artwork	Frontend Support Forums	Pinball	Forum Discussion	Old Boards
Raspberry Pi & Dev Board	controls.dat	Linux	Miscellaneous Arcade	Wiki Discussion	Old Archives
Lightguns	Arcade1Up	Try the site in https mode		Site News


Unread posts \| New Replies \| Recent posts \| Rules \| Chatroom \| Wiki \| File Repository \| RSS \| Submit news

Author Topic: Newbie HAPP 3" Trackball setup (Read 912 times)

Wzrd0803

Newbie HAPP 3" Trackball setup

PL1

Re: Newbie HAPP 3" Trackball setup