| Main > Everything Else |
| Seriously WTF |
| << < (13/15) > >> |
| Howard_Casto:
Yes I'm not suggesting a franken panel. Like you could do a beat em up cab styled after the konami cabs.... then all the dynamic art, side art, ect would line up and just work because the physical dimensions are the same. The projection thing isn't super hard.... they make rear projection films where it "just stops" the light from going every where and only displays the image. You might also need two projectors at opposite angles above the below the center of the control panel. You'd still see the square joystick base, but the dust cover covers most of that up anyway. Buttons and spinners have a slim profile so it'd be possible, with careful positioning of the switches, to get near perfect results around them. Trackballs or more obscure controls would probably be out... although that one 3d printed low profile trackball is still out there. |
| Mike A:
Why don't you just use like 6 projectors. You could wear one on your head. |
| pbj:
Just put an x arcade on your lap and slap on a VR headset. :dunno |
| Howard_Casto:
VR still has a way to go... as-is I'd probably get a headache or throw up before I made it through Turtles in Time. Eventually that might be the way we all do it though. |
| Osirus23:
I prefer setting an Xbox One controller on top of a non-functional control panel and using it to play games. Also there is no arcade monitor in the cab, just a laptop sitting on the monitor shelf but don't worry I have plans to finish it someday. For now this works. |
| Navigation |
| Message Index |
| Next page |
| Previous page |