Hi
Thanks for the explanation
But before I saw you post I have been been changing all the CAP's at the power supply side.
C121
C123
C125
C129
C114
C112
C111
C107
C144
C137
And also C14 at neck board
Now i can adjust the B+, I have set it to 139V BUT now i do not have any neck glow or white picture
SO i have tested the R35 on neck PCB I messure it to 1.5 Ohm.
In the diagram it must be an 0.68Ohm - so can it be my issue now?
I do not have any 0.68 Ohm 1W resistor in my spare parts... so if its that is my issue now I have to order some
I might also check the volts according to your guide
Thanks again for your help!