April 26, 2024, 02:55:15 am
Home
Help
Search
Login
Register
News:
Support this site
Shop
Amazon
through our link. Thank you!
Forum notices to gmail.com addresses are working. Microsoft addresses are still not.
The NEW Build Your Own Arcade Controls
|
Main
|
Main Forum
|
I-PAC2 Firmware Upgrade Mode - Which Pin?
Main
Restorations
Software
Audio/Jukebox/MP3
Everything Else
Buy/Sell/Trade
Project Announcements
Monitor/Video
GroovyMAME
Merit/JVL Touchscreen
Meet Up
Retail Vendors
Driving & Racing
Woodworking
Software Support Forums
Consoles
Project Arcade
Reviews
Automated Projects
Artwork
Frontend Support Forums
Pinball
Forum Discussion
Old Boards
Raspberry Pi & Dev Board
controls.dat
Linux
Miscellaneous Arcade
Wiki Discussion
Old Archives
Lightguns
Arcade1Up
Try the site in https mode
Site News
Unread posts
|
New Replies
|
Recent posts
|
Rules
|
Chatroom
|
Wiki
|
File Repository
|
RSS
|
Submit news
« previous
next »
Send this topic
Print
Pages: [
1
]
Go Down
Author
Topic: I-PAC2 Firmware Upgrade Mode - Which Pin? (Read 1031 times)
0 Members and 1 Guest are viewing this topic.
pacboy
Trade Count:
(
0
)
Full Member
Offline
Posts: 44
Last login:December 24, 2019, 09:18:52 am
I-PAC2 Firmware Upgrade Mode - Which Pin?
«
on:
October 13, 2018, 04:45:37 pm »
On the Ultimarc website, it shows how to put the I-pac2 into firmware upgrade mode using the "hard" method:
https://www.ultimarc.com/fwupgrade.html
The picture shows a wire connecting the pin on the lower left to the ground screw. I have the newer version of the I-pac2 , which has been redesigned and now has two rows of 10 pins:
http://ultimarc.com/ipac1.html
Which pin on the new design should be connected to ground?
Thanks for any advice.
Logged
AndyWarne
Trade Count:
(
+18
)
Full Member
Offline
Posts: 1938
Last login:April 11, 2021, 03:37:09 am
Re: I-PAC2 Firmware Upgrade Mode - Which Pin?
«
Reply #1 on:
October 13, 2018, 09:01:54 pm »
The newer boards dont have this "Hard" method. It should not be necessary.
If there is a problem upgrading firmware I can assist via email.
andy@ultimarc.com
Logged
Send this topic
Print
Pages: [
1
]
Go Up
« previous
next »
The NEW Build Your Own Arcade Controls
|
Main
|
Main Forum
|
I-PAC2 Firmware Upgrade Mode - Which Pin?