how would you print these button labels? Do you just print them on good quality paper with an inkjet?
Clear adhesive labels are better than paper labels -- better light transmission, no visible fibers.
You can inkjet print your own inserts like the ones
here or
here on
Avery 18665 (10 pack) or Avery 8665 (25 pack) media.
If you have a laser printer, use Avery 15665.
Do you use the original disk as well, that the button comes with or just the printed label?
Attach the adhesive Avery label to the diffuser (2nd from right), then carefully trim the excess.
- I usually put the label adhesive-side up and carefully lower the assembled plunger and diffuser onto it.
- The plunger legs are a convenient handle while trimming the excess.
- Inkjet ink flakes off very easily so print extra labels for just such an emergency. [/Foghorn Leghorn]
You may want to apply a ***small*** amount of superglue to keep the diffuser from turning under the cap.
Obligatory "
CSI warning": Allow the superglue to dry and offgas
completely before assembling the buttons or they might end up like this.
Scott