Hi Guys,
I'm at the point in my project where I'm getting ready to program controls for all the emulators. I'm going to be using two U360s with the 8 button harnesses. I'm running pretty much all 8 bit and up emulators. Had a couple questions:
1. At this point I only have one U360 joystick. I don't have the harness for it yet either. I know the answer is probably no, but using Joy2key or Xpadder, can I begin to set the controls for each emulator before I pick up the other stick and both button harnesses, or do they all need to be hooked up to be able to do it? I'm trying, if possible, to get the system ready so that when I get the other stick, both harnesses and buttons, I can just plug them in and it's all ready to go.
2. Do you use Joy2Key/Xpadder for all emulators on the system, or is it best to use the default key layout in MAME, and then use J2K/Xpadder for all the rest? I'm trying to figure out the best place to start in terms of creating a layout.
I've not looked forward to doing this. For some reason it seems a bit daunting to set it all up correctly so that everything works and is controlled right. Any advice and info is truly appreciated. Thanks.
Oops, should have probably put this in the Software forum.