Thank you. I checked the connections and they are in the right place. As I mentioned, it was working for a couple right after I changed the Mechanism control. After that the Mech went bad again and started doing the carousel move, cd place, replace, move, etc.
The only think I can possibly think is maybe the gripper arm motor or the scan motor may be going bad and drawing too many amps? Is that possible? Or, something is wrong with the power supply? I doubt the CCC can damage the mech, but not 100% sure.
Those are the only possible things I can think of at the moment. Not sure how far off base I can be with that. Thoughts from the group?
Thanks