Author Topic: I-pac ultra and 12v led strips- can I pull it off? (Read 1236 times)

rackoon · « **on:** October 21, 2016, 12:05:42 am »

Ok, I got a I-pac Ultra and have a cab with a lot of led effects on the sides, around the bezel, and of course the control panel. These are all 5v and I know I can just wire them up to the I-pac. But, I want the halo effect around the bottom using green led strips. I was going to break them up into strips of three or four so I can make them blink at different times using (led blinky). Unfortunatly, all the led strips I can find are 12V. Any Ideas? Is there any way to make this happen?

drewjbx · « **Reply #1 on:** October 21, 2016, 01:08:02 am »

Pics?

Sent from my iPhone using Tapatalk

Titchgamer · « **Reply #2 on:** October 21, 2016, 02:02:26 am »

Well you could probably run the 12v ones on a 5v supply but they will be dim.


Main	Restorations	Software	Audio/Jukebox/MP3	Everything Else	Buy/Sell/Trade
Project Announcements	Monitor/Video	GroovyMAME	Merit/JVL Touchscreen	Meet Up	Retail Vendors
Driving & Racing	Woodworking	Software Support Forums	Consoles	Project Arcade	Reviews
Automated Projects	Artwork	Frontend Support Forums	Pinball	Forum Discussion	Old Boards
Raspberry Pi & Dev Board	controls.dat	Linux	Miscellaneous Arcade	Wiki Discussion	Old Archives
Lightguns	Arcade1Up	Try the site in https mode		Site News


Unread posts \| New Replies \| Recent posts \| Rules \| Chatroom \| Wiki \| File Repository \| RSS \| Submit news

Author Topic: I-pac ultra and 12v led strips- can I pull it off? (Read 1236 times)

rackoon

I-pac ultra and 12v led strips- can I pull it off?

drewjbx

Re: I-pac ultra and 12v led strips- can I pull it off?

Titchgamer

Re: I-pac ultra and 12v led strips- can I pull it off?