| Main > Everything Else |
| Golden Tee 2001 -2006 CHD's and the U53's, Big Buck Hunter, Carnival King |
| << < (4/17) > >> |
| ed12:
in fb button m toggles the rest pin from high current to low also make sure your printer port is set to bi or/st not ecp nor ecd ed |
| Loopey1:
Got Ya. I will try. |
| Loopey1:
Well, I am on my third computer, thinking My port may not have enough power to drive the fuse bits. I have tried a P4 box a P3 box and my old AMD quad core. I could try my old 486 100 DOS programmer box, but that will not boot from a USB so I would have to make a 3.5" disk with the files on it. and this is what I get every time. |
| ed12:
try this file it loads a .hex only no eep ed |
| Loopey1:
Same error. ??? I will try another PC again. This was just off my old DOS box so.... Do I need an external 12 Volt power supply on pin 1 of the Atmel? All of the HV programmers I see have an external power supply to reset the fuse bits..... But none are the simple one I made so... I wonder if that could be a issue? Not enough power to reset the bits? |
| Navigation |
| Message Index |
| Next page |
| Previous page |