Main > Everything Else
Golden Tee 2001 -2006 CHD's and the U53's, Big Buck Hunter, Carnival King
<< < (3/17) > >>
ed12:
this file will make your usb stick bootable
with free dos

usage
open jzip >extract<
rufus.exe
click  on rufus
u will get a drop down
follow the prompts
once done, leave usb stick in and reboot your box
it will boot auto to free dos and or give u the opition
u will then load the other files to the same usb stick

ed

Loopey1:
Just a quick question or two.
What should the Device ID be for the Atmel chip? (when I select get ID)

And second. Do I load Both Hex files at the same time?

IE load Flash.hex into buffer, and then load EEP.hex into eeprom buffer? All in the same operation? Or load Flash hex, program, then load eep.hex and program again?

It has literally been years sense I have used this DOS program my last 2313, and my rusty is showing.
Loopey1:
Alrighty, I made a simple AVR programmer. DB25 powered using the schematic listed in the FB.exe program. 

Like this one. http://www.nekhbet.ro/wp-content/progavr1_d.jpg

I was able to find a old g42-us-u chip. IIRC this is a GT2002??? 
anyways, I connected that to the simple programmer booted to FreeDOS loaded the fb program, loaded the hex files and clicked program.
It went through all of the paces but in the end it said something about a low byte error at 0000
for both flash and eeprom.

I then attempted to read. nothing, still locked. I verified this in my VP-288 (says security bits set)

ed12:
u toggle the fuse byte to high voltage.
worst case I will up-link a all in 1

ed
Loopey1:

--- Quote from: ed12 on March 27, 2015, 07:23:28 pm ---u toggle the fuse byte to high voltage.
worst case I will up-link a all in 1

ed

--- End quote ---

Do what? Please explain how to do that.
Is there something else I need to build that goes along with that simple programmer?
There is no mention of applying High Voltage to anything in your previous directions....
How high of voltage? What Pin or Pins?

You have my attention. :)
Navigation
Message Index
Next page
Previous page

Go to full version