Thanks stavros, appreciate it.
I was able to do some of the minor cleanup stuff today.
1 - I decided to make my own marquee out of the left over plexi. I broke the line about 1/8 inch larger than where i wanted my finish cut and used my router with a flush trim bit to clean it up. Came out really clean. (the jaggies in the pic are from the plastic protective layer), I cut the aluminum angle today using my miter saw with a 60T blade. Worked perfectly fine. I got the angle that is 3/4 x 1/2 so the part hanging over the marquee is smaller than where the screws will go.
2 - Found some USB panel mounts that i can use for the front of the CPO. I'll try some test fits to see if i can get a flush mount working.
3 - Finally got the monitor mounted, but it's about 2mm off center.
I wasn't really happy with the way the mount came out anyways, I'm going to redo it tomorrow and center it.
4 - My design called for a small rabbet cut with the router to slide the plexi up into the speaker mount. This keeps it in place and makes a really nice clean line. it looks like it's at an angle in the pic, but it actually looks really clean with the plexi in place. (besides everything being filthy from routing MDF
I'm going to add in a stop at the bottom (under the control panel) for the plexi to rest on. It will be squeezed by the cpo and rabbet cutout at the top.
power switch will be here tomorrow, and lighting on thursday. My plan is to do some painting this weekend