Main > Driving & Racing Cabinets
M.A.M.E.-ing a SEGA Hang-on cabinet to play Motocycle- and Jet Ski-games
synonym9:
Thanks BadMouth for the hint :applaud:
How is that with 2 functions on one axis to understand?
Is it a pot that is centered and sends the signal for acceleration if turned in one direction and for breaking if turned in the opposite direction?
I am just on the site of the U-Hid to get some enlightment....hope I understand it.....
synonym9:
--- Quote from: BadMouth on November 03, 2013, 10:47:48 am ---
--- Quote from: synonym9 on November 03, 2013, 10:21:23 am ---
Would the U-Hid work with the original pots or....?
--- End quote ---
IIRC Hang-On had the brake and throttle wired together as one axis, so that might need to be undone to separate them.
--- End quote ---
I still dont understand what that means....please explain.
I won the cabinet and pick it tomorrow....so all advices are valueable
BadMouth:
--- Quote from: synonym9 on November 05, 2013, 03:10:10 pm ---
--- Quote from: BadMouth on November 03, 2013, 10:47:48 am ---
--- Quote from: synonym9 on November 03, 2013, 10:21:23 am ---
Would the U-Hid work with the original pots or....?
--- End quote ---
IIRC Hang-On had the brake and throttle wired together as one axis, so that might need to be undone to separate them.
--- End quote ---
I still dont understand what that means....please explain.
I won the cabinet and pick it tomorrow....so all advices are valueable
--- End quote ---
Well, I'm not sure if it was or not. Just thought I remembered a comment about it being that way.
Check the manual.
I haven't done it.
It's either this:
(jacked from this thread: http://forum.arcadecontrols.com/index.php/topic,12551.0.html )
or this:
M2 emulator requires separate axis (it's about the only thing that does).
synonym9:
I understand it now.
Maybe I dont a clue about that but for my understanding it is not a big problem. When I dont use the stock-harness (which I wouldŽnt if I go with the U-HID) I would have seperated axis, right?
I wire every pot seperately in the U-HID and I shouldŽnt have a problem.
I already have the cabinet at home and started to dismantle it, would be nice if you join in that thread too:
http://forum.arcadecontrols.com/index.php/topic,135594.0.html
Ps: I just checked it, its like you said, even 2 of the 3 cables go through both pots.
I rather see the problem when I comes to emulate Hang-On because of the that system and the fact that its not like that with the U-HID.....but maybe I am wrong on that...
Howard_Casto:
I should really start paying attention to this threads. As I mentioned in the other one this is not the sit-down model, it is the upright model.
I'm not being picky it's just a few years from now somebody is going to be searching the forums to get info on the sit-down, run across this, and be disappointed.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version