Woodshop lab has started. This first lab (following last weeks boring but mandatory machine safety lab) was extremely short (1 hour versus the normal 2 1/2 to 3 hours). I spent most of the time discussing plastic cutting issues with the instructor and trimming the marquee to it's rough vertical size. I had hoped to get the top and bottom edges flush trimmed and finished but ran out of time.
Sides won't be cut until October, so I'll be using the lab sessions up to that point for the parts that don't rely on the finished sides... specifically the marquee and its "lid" and bottom panels, the nav panel, the mini marquee, and the control panel.
Next week I'll finish the marquee edges and hopefully drill the CP. I plan on using the same technique for cutting and bullnosing my trackball hole that I used on my first CP... this time I'm going to document it though.