hi
this is a small list i pulled from my part's box
1=creative lab's ct7260
2=mic d33005-full part # cn-odk002-69861-660-000d
3=it's gamming part # 2025 rev-1
if u need it by friday order from it's gamming
link here
>
http://www.itsgames.com/itsgames/<
there is a simple rule of thumb to follow
if it fit's the slot, it will work in the game..
these board's like 256-512meg of video ram,
i use spare part's house's..after all we are dealing with 10+ year old game's,they usally have what i need..or i scavage from a old winxp box
make sure it work's then stick a fan on it....
!!!!that is what killed your old 1!!!!
and clean out the powersupply fan or better yet replace it
with a new :non-atx: supply
as the most of the green board's used non atx style supply
unless it is a newer style with the atx plug ?
now the rule here is what i stated
your video hook up is off of a riser plug
then u hook to a 15 pin to 15 pin plug to hook back into the board
where it then go's to the jama harness
u can easyly make a 12 volt feed fron the onbaord 4 pin power plug's
1=to the harddrive
1=to the cdrom
tie the video card fan there
ed