Custom Multicade Control Panels for PGA Tour Cabinets

[milkit]

I have three custom made control panels that are designed to be direct replacements on PGA tour cabinets.

I have two with joysticks on the left of buttons and one "left handed special" that has joysticks on the right side of the buttons.


All 3 have two players with 8 buttons each and a recessed trackball cutout. With this, you can put in a trackball mount and it will be flush with the board. I can drill extra buttons for "admin" or whatever for $1 each

All 3 are 5/8" thick and had an offset t-molding slot so that you can use 1/8 inch plexi over the panel and then 3/4" t-molding will be flush.


Bottoms are routed out where joysticks go.

Control panels are $30 for the wood panel only. Add another $30 to add plexiglass to that. Plus actual shipping. I ship flat wrapped in cardboard, the last one i sent was only about $17


The photo of the red and blue panels show what these look like complete and finished. The black one is a different panel I made but it just shows you what it looks like once you put in a trackball mount, puddy it in, and paint over.

[milkit]

crap. wrong section. I am dumb. please delete this.