Hey all! This sub-forum never catched my eye before!!
Well, I hope someone can help:)
I'm fixing a Blackout, and I've rebuilt the blanking circuit, since it didn't work. I've also changed
the 40-pin connector on both the CPU and driver board.
The blanking test point on the CPU board shows 4.6V, so that's good. Pin 37 also shows 4.6V, so also
good there.
However, the feature lights and coils doesn't come on. All fuses are checked, and OK.
I'm thinking that maybe there is a fault on the driver board, that stops it from turning on?
Any advice would be VERY welcome!!
Thanks!
Nicholas