Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: My Robotron Repo CPO (ehh)  (Read 1281 times)

0 Members and 1 Guest are viewing this topic.

delta88

  • I didn't try to trick anyone - Fair warning was given
  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 657
  • Last login:May 20, 2025, 08:21:05 am
  • This place is still here?
My Robotron Repo CPO (ehh)
« on: May 03, 2005, 01:09:40 pm »
OK so I got this mint robotron but the control panel needed a new overlay. So to ebay I went. I picked up a relativly cheap repo from a uy in Plantation,Fl. dunno his ebay name its been so darn long but last night I decided to finally put it on.

For whatever reason the holes on the new cpo don't match for cr@p and it was like 1.5mm to short on the sides. Hardly notiable once installed.

well take a look. the pictures explain themselves.

 -d88







« Last Edit: May 03, 2005, 04:53:42 pm by delta88 »
Logged
Pages: [1]
  
Go Up
« previous next »