Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: Problem getting monitor to work  (Read 1169 times)

0 Members and 1 Guest are viewing this topic.

Prodarkangel

  • Trade Count: (0)
  • Jr. Member
  • **
  • Offline Offline
  • Posts: 2
  • Last login:April 02, 2009, 10:28:40 pm
Problem getting monitor to work
« on: April 02, 2009, 04:27:13 pm »
So I have a 33" arcade monitor that i have hooked up and it works. I turn it on and it shows green lines go across the screen. It is jamma. I have the pcd and a VGA breakout cable to use to connect to the jamma pcb. When ever i plug it in with the soft15khz and set to the 600 by 480 resolution it does nothing really you can tell it changes when i plug it in. But it stays the green wavy lines. Any hints would help out. I can post my monitor if needed
Logged

SirPeale

  • Green Mountain Man
  • Global Moderator
  • Trade Count: (+23)
  • Full Member
  • *****
  • Offline Offline
  • Posts: 12963
  • Last login:August 04, 2023, 09:51:57 am
  • Arcade Repair in New England
    • Arcade Game and Other Coin-Op Projects
Re: Problem getting monitor to work
« Reply #1 on: April 02, 2009, 07:18:02 pm »
Logged
Pages: [1]
  
Go Up
« previous next »