Arcade Collecting > Pinball
Jungle Lord - Ball wont pop into plunger area
vertygo:
Love it, played it alot last night, but this morning the ball(s) won't pop up in front of the plunger. I don't really know all the terminology yet, so I apologize. But basically the plunger area is empty, there is a ball in the recessed area directly beside it, and the other ball is sitting behind that.
I gather that the game thinks there is a ball in play, but even if I take the ball out and start, it wont pop the next ball into the plunger area after the current one drains.
Jungle Lord is a System 7 pin if that makes any difference.
IPDB Link
Also, what are the 3 AA batteries for ?
Cheers
SirPeale:
The batteries are for saving settings.
Check the switch on the ball drain, make sure it registers. In fact, it's a good idea to check all your switches to see if they're operating correctly.
vertygo:
How would I test them ?
Also, I want more power in the flippers, should I get a specific Jungle Lord flipper rebuild kit ?
ChadTower:
If you're going to rebuild the flippers you want two of these.
smartbomb2084:
Your shooter lane delivery problem could also be solenoid related. As far as testing switches and solenoids go, it is explained in detail in the operations manual and/or operator's handbook. If you don't have them you can download them from IPDB. The three AA batteries need to be changed immediately, unless you have already done so, or know how old they are. Better yet the batteries should be removed from the CPU board and relocated with a remote battery holder so if they leak no board damage will occur. If you want to rebuild your flippers don't buy the kit from the previous post. Your flipper bases have non-removeable coil stops. you need to buy newer style bases and the coinciding rebuild kit so you can get new coil stops with the kit. Just as I have done with my FIREPOWER.
Navigation
[0] Message Index
[#] Next page
Go to full version