Author Topic: Happ 19" Vision Pro (Read 1749 times)

sfrascella · « **on:** February 01, 2007, 01:31:13 pm »

I just got a Happ 19" Vision Pro monitor for my Defender project, and the installation looks pretty straight forward but I wanted to run it by the group first before I do anything that could possibly damage it. It looks like I connect the red, green, blue, ground, v-sync, and h-sync to the corresponding pins on the board and then power it up.

Is this the case or am I missing something here? I know this is a total noob question, but this is the first time I have installed one of these.

Thank's for any help or advice.

Rickn · « **Reply #1 on:** February 01, 2007, 09:08:04 pm »

Just Browsing, but before you plug it in- look for stickers or warnings... IS AN ISOLATION TRANSFORMER REQUIRED!!

If so make sure you use it or you will blow fuses, regulators...

Good Luck

Rick
Nieman Video Displays
Niemandisplays.com

sfrascella · « **Reply #2 on:** February 01, 2007, 09:29:57 pm »

Thanks Rick, no isolation transformer is required with this one. I installed it tonight and it works perfectly. It actually was pretty easy, but since I had never done it before I was a little nervous.


Main	Restorations	Software	Audio/Jukebox/MP3	Everything Else	Buy/Sell/Trade
Project Announcements	Monitor/Video	GroovyMAME	Merit/JVL Touchscreen	Meet Up	Retail Vendors
Driving & Racing	Woodworking	Software Support Forums	Consoles	Project Arcade	Reviews
Automated Projects	Artwork	Frontend Support Forums	Pinball	Forum Discussion	Old Boards
Raspberry Pi & Dev Board	controls.dat	Linux	Miscellaneous Arcade	Wiki Discussion	Old Archives
Lightguns	Arcade1Up	Try the site in https mode		Site News


Unread posts \| New Replies \| Recent posts \| Rules \| Chatroom \| Wiki \| File Repository \| RSS \| Submit news

Author Topic: Happ 19" Vision Pro (Read 1749 times)

sfrascella

Happ 19" Vision Pro

Rickn

Re: Happ 19" Vision Pro

sfrascella

Re: Happ 19" Vision Pro