Main > Main Forum

Joystick stuff I messed some things up!??!!?

<< < (3/6) > >>

rdowdy95:
Anyone else using the MS PacMan reunion stick?

AlanS17:
In diagonal it should hit one switch, but never two. Hitting two switches will actually cancel each other out in a 4way game, and neither switch will register. I'm not the one to be giving advice, though. I don't have mine in front of me.

For future reference, loosen the clip by wedging a screw driver under it. You'll save your fingers a world of pain. (Just make sure it doesn't go flying. You can do that by putting a plastic bag over it while you take it off.)

shardian:
Here is my thread from awhile back when I had a problem with my reunion stick.
http://forum.arcadecontrols.com/index.php?topic=54918.0

Maybe it will help you a bit.

Also when taking out e clips, I use a small flat blade screw driver to slightly work off the e-clip, then get it off the rest of the way with a pair of needle-nose pliers. Works everytime with no flying parts. ;)

rdowdy95:
what part is a pivot cone.

rdowdy95:

--- Quote from: AlanS17 on October 31, 2006, 01:24:45 am ---In diagonal it should hit one switch, but never two. Hitting two switches will actually cancel each other out in a 4way game, and neither switch will register. I'm not the one to be giving advice, though. I don't have mine in front of me.

For future reference, loosen the clip by wedging a screw driver under it. You'll save your fingers a world of pain. (Just make sure it doesn't go flying. You can do that by putting a plastic bag over it while you take it off.)

--- End quote ---

So if I hit diagnol now with actuator it doesn't hit anything.  When I flip it though it only hits one switch so I will go ahead and set it like that like the picture on happ.  On the reunion stick on Happ it shows just  a side shot.  That way actually hits one switch in a diagnol.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version