Arcade Collecting > Pinball
The Shadow
ChadTower:
--- Quote from: pinballjim on September 30, 2008, 05:08:37 pm ---You sure about that? You've never once had to clear a credit dot because your brick wall stopped working?
--- End quote ---
Not once. Battlefield target issues but none at all with the brick wall.
ChadTower:
Finally got some flipper rebuild kits for this game. Rebuilt the left flipper and put a new rubber on it... now it is hitting the right ramp normally. I didn't think the linkage on the old part was all that bad but maybe it was. Or maybe the new rubber is the big difference, who knows (The Shadow knows).
Left orbit lane switch is acting up again even after I pulled it out and adjusted it. It works if I manually push it but doesn't seem to register rollovers. Probably just needs to be replaced as I don't want to bend the arm any more than I already have.
Next up is rebuilding the upper flipper and aligning it so it's easier to hit the mode start shot that way. Right now I seem to have a very low success rate with that shot and I'm told I should be able to just hold the flipper on an orbit and it will bounce right in.
Navigation
[0] Message Index
[*] Previous page
Go to full version