Arcade Collecting > Pinball
The Shadow
ChadTower:
Pics. I highlighted the relevent area because I couldn't get the lighting right. The burns are worse than it appears in the photo because the color is off due to the lighting.
If you zoom in on the pcb front with components out photo, the trace I lifted is just to the left of the fuse holder, above the rightmost orange circle cap.
ChadTower:
Okay, have about half of the components back in... spent a good amount of time running buzz checks to make sure the traces are intact. All looks as good as I can tell so far. I am going to stop here for now because I need to get some 24g wire or wire wrap to jump that lifted trace. I'm not sure how much room I'll need to do it well so I'm not putting the surrounding pieces back in yet. Don't have 24g wire on hand unless I want to snag some from the cat6 on the shelf and I'm not sure if that is stranded or solid. Radio Shack isn't open right now.
And someone from rec.games.pinball offered to send me a batch of 3.8A fuses free. Sweet.
ChadTower:
Almost done rebuilding...
NOTE: Solder heat sinked components into the board BEFORE reattaching the heat sink to it. It's awfully hard to heat up a heat sinked component. :banghead: :banghead:
ChadTower:
Rebuild complete... waiting on fuses to arrive in mail so I can test.
gamecreature:
Anyone for Peking Duck? ;)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version