another robotron control panel fixer upper thingy :)

[westell]

Its been done over and over and it gets done over again

This one was wee bit harder but it turned out nicely. The tricky part was fixing the holes where the T nuts go which was done by adding some stiff wire in an offset x ways pattern to hold the bondo during a hardcore game. I gave it a good pull tug and jerk to make sure everything was good to go before putting on the cpo

If i can find some 4" red ball shafts i"ll be good to go

[westell]

more

[Luigi]

Nice job


I have to fill one added hole, too.....but it's metal, not wood 

[psychotech]

!

That's great. Nice work, what else can I say