Main > Main Forum

cutting MDF which is better router or circular saw

(1/4) > >>

kiddk1:
i am cutting out my CP and needed advice on what to use on the mdf for cutting it.

miles2912:
Saw board and circular saw.  Not as messy and will make a clean straight line.  The only time you would want to route MDF is when you are using a pattern bit to make a copy of one side.

Don

babydickonboard:
another vote for circular saw + jig.

Tahnok:
A circular saw is better, if you also have a jig saw to make curves. If you are only looking to buy a single tool, a router is more versatile.

cnlmoore:
Circular saw is good as long as the panel is fairly large.  Cutting smaller pieces of MDF with a circular saw can be dangerous if not done properly.  Table saw would be the best bet.  MDF + router = a ton of dust.  You would have to make multiple passes to cut clean through.  OK to use for a joystick or trackball cutout as it does provide nice clean edges.  Good luck.

Navigation

[0] Message Index

[#] Next page

Go to full version