Main > Main Forum
use router flush bit to flush cut the CPO?
bossyman15:
checked wiki and artwork FAQs but i don't see anything about this.
i have CPO from mamemarquee.com and i don't want to remove the sticky side off the sticker sheet. so here's what i want to do.
put CPO on CP and put plastic sheet overlay on top of it and clamp it down and use flush bit to route flush the CPO to CP.
is that safe for CPO? will it tear it out or is it fine?
AtomSmasher:
I cut mine by clamping in place, then using an exacto knife to cut it.
leapinlew:
--- Quote from: AtomSmasher on April 28, 2006, 09:26:44 pm ---I cut mine by clamping in place, then using an exacto knife to cut it.
--- End quote ---
Yes exacto knife!
I think the router may tear it out. Man, thats some serious marquee cutting power!
bossyman15:
--- Quote from: leapinlew on April 29, 2006, 01:51:52 am ---
Yes exacto knife!
I think the router may tear it out. Man, thats some serious marquee cutting power!
--- End quote ---
ummm odd... where did i say maruee?
but all that aside... ok i will use exacto knife (brand new one). i just like using router.
mccoy178:
The router will not tear it! It has such a high revolution rate, it takes it right off. Using that router will make a nice clean cut.
Navigation
[0] Message Index
[#] Next page
Go to full version