Arcade Collecting > Pinball
My Pinball Playfield Swap - Stargate - All Electronics Done!
Buddabing:
--- Quote from: Witchboard on December 20, 2005, 03:03:39 pm ---I was interested in the process that Budda used to scan his playfield.
--- End quote ---
I had it professionally done. I own a flatbed scanner, but it is a large multifunction printer. I would have had to take scans of many pieces and stitch them all together. Very difficult considering one little shift in angle can cause the stitch lines to be visible.
Considering all I paid for the scan was gas to drive about 60 miles, it was well worth it.
Witchboard:
I'd say so. ;D Thanks. Project is looking good, so keep it up.
ChadTower:
--- Quote from: Witchboard on December 20, 2005, 03:03:39 pm ---This is an old EM machine that I'm looking at.
--- End quote ---
Edgedamage:
I did playfield swap in an Alien Poker in the mid 90's I took my time but it was worth it. The original owner used a chipped ball which killed the original playfield. Use your digi cam and take pics so you have a refence. I was lucky and at the time I had two AP's so I could do a refence check.
ChadTower:
--- Quote from: Edgedamage on December 21, 2005, 11:38:27 am ---I was lucky and at the time I had two AP's so I could do a refence check.
--- End quote ---
???
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version