Arcade Collecting > Pinball
My Pinball Playfield Swap - Stargate - All Electronics Done!
Buddabing:
The left VUK is fixed now. I put in some washers to shim it up a little bit.
What's happening to the outhole is that the outhole kicker is sometimes causing the ball to bounce back. There's a one-way gate that the ball goes through. That gate is not closing fast enough sometimes, and the ball occasionally will get through back through the entrance to the gate. This causes what appears to be multiple drains from one actual ball drain.
For some reason, the game doesn't launch the fourth ball when in multiball mode.
The 40M switch isn't working.
Buddabing:
I got the 40M switch working. I haven't solved the bounceback problem yet.
GreenKnight37:
Seeing as how I need to do a complete swap on my Swords of Fury pin (thankfully I have a sweet NOS playfield, fully populated and original!) I have a general question...
How did you go about learning most of what you did? I haven't had much chance to research all the mechanics, so I dont know what does what on a lot of my pin. I know RGP would help me out (when they're not having flame wars with certain Australian business owners), but did you go anywhere else for info? I'm always looking for good, dedicated pinball websites, but I've never stumbled on a very active board like BYOAC or anything similar.
Buddabing:
I searched for playfield swap web sites and asked questions on RGP, but a lot of stuff I had to learn via trial and error.
Please feel free to PM me if you have any questions.
Navigation
[0] Message Index
[*] Previous page
Go to full version