Arcade Collecting > Pinball
My Pinball Playfield Swap - Stargate - All Electronics Done!
Buddabing:
The plan is to lift the playfield up, then scoot the cabinet out of the way towards the back of the room, then transfer the playfield over to the rotisserie.
All did not quite end well, however. One of the flippers is stuck in the up position now. I think I must have bumped something on the flipper coil which is quite close to the edge of the playfield.
The cabinet is filthy inside and it stinks in there, so my hands got really dirty from working in the machine.
TheOtherBob:
Now is the time to sand the inside of the cabinet a bit and put a fresh coat of black paint in there. That is if it needs it. It sure makes them look nice on the inside.
Good luck on your project!
ChadTower:
Scoot the cabinet out of the way?
Secure the two clothes racks to each other, then put them on wheels, so you can move the playfield out of the way. It is the smaller item.
Buddabing:
--- Quote from: ChadTower on December 12, 2005, 10:17:34 am ---
Scoot the cabinet out of the way?
Secure the two clothes racks to each other, then put them on wheels, so you can move the playfield out of the way.
--- End quote ---
Buddabing:
I had a high-resolution scan (300 dpi) made of the entire playfield. The image was a 13800 by 6075 TIFF. Here it is, greatly reduced, along with a selection showing some text. Text is hard to scan.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version