Main > Main Forum
Betson Imperial Trackball
Fozzy The Bear:
I've managed to aquire one of these trackballs..... I'm still waiting for delivery on it. it might be a while getting here :( , but it has some significant advantages....
3" ball, fully enclosed case and it's PS2 as standard with three button wires... no mouse hacking or optipac interfaces needed.
I'm trying to lay out my control panel and I was wondering if anybody has a dimensioned drawing or has one they could measure for me, I need to try and fit my buttons round it and don't know where they need to go to avoid the case.
Can anybody help with this please???
Best Regards,
Julian (Fozzy The Bear)
pmc:
Assuming it's the same size as the Happ 3" ball, there's a drawing in the Arcade Art Library here. I'm not certain if the housing is the exact same size or not.
-pmc
Fozzy The Bear:
Thanks for the tip, but unfortunately they are entirely different to the Happ Trackballs and come in a sort of diamond shaped case....
Thanks anyway!
Can anybody else help out here??? I know some of you guys have got them.... Please??
Best Regards,
Julian (Fozzy The Bear)
markrvp:
--- Quote from: Fozzy The Bear on October 30, 2005, 03:53:39 pm ---Thanks for the tip, but unfortunately they are entirely different to the Happ Trackballs and come in a sort of diamond shaped case....
Thanks anyway!
Can anybody else help out here??? I know some of you guys have got them....
--- End quote ---
zaphod:
Yes, the mounting plate will be the deciding factor on how close it is to the buttons. If you go with a mounting plate the ball itself is irrelevant. Wait until you get the trackball before cutting the hole out, though, to make your life easier.
Navigation
[0] Message Index
[#] Next page
Go to full version