Main > Main Forum

grr anybody have the special bit for nintendo guns

<< < (2/4) > >>

Crazy Cooter:
I could use one of those too for future use.

Is that the right one?  They don't provide a pic of the actual head.

tray262:
I look for a security bit kit. I get them at the local flea market. It's normally a 30 piece set or so. Has some very weird bits. but they work great. I wouldn't buy the gamebit, If I remember correctly the gamebit that they sell is mostly for the gamecube and it's going to be too big. I think you're better off with this http://cgi.ebay.com/33pc-SECURITY-BIT-SET-torx-hex-star-bit-screwdriver-237_W0QQitemZ6006828693QQcategoryZ50383QQrdZ1QQcmdZViewItem

Good luck!
Tray

Crazy Cooter:
I don't think that has the right bit.  It's kind of a "cog" shape.  Almost a reverse torx bit... almost, but with flat spots like a gear.

Franco:

--- Quote from: DaemonCollector on October 16, 2005, 09:25:27 pm ---Take a bic pen, remove the ink tube. Using the plastic tube heat it with a lighter untill its mushy. Jam the mushy plastic into the hole over the screw, allow to harden, you now have a new bit :)

--- End quote ---

Seriously, if you want to do it now use this method. Thats what I did to remove the security screws on my n64.

Crazy Cooter:
I don't know if that would work.  There is a nut on the back of the bolt that is set in the plastic tight enough that the plastic holds it.  Any rust involved would probably snap the plastic bit.  It's worth a try though.  Especially on mine since it's rust-free  ;).

I tried taking a pic of the bolt head... then touched it up  ;).

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version