Main > Main Forum

grr anybody have the special bit for nintendo guns

<< < (3/4) > >>

meanbean:
Crazy Cooter, that is exactly what a gamebit screw driver looks like.  I've seen people use other materials besides remolded plastic to get these screws out so do whatever it takes but remember there is aways an easier way.  Good luck to you.

Crazy Cooter:
Cool, I wasn't sure because the pic on lik-sang didn't show it.

meanbean:
Np...Lik-Sang is not the only place to get it but they have reliable service and reasonable prices. If you're in the States then you can pick one up from NSC for a little less.

Vigo:
I'm just curious, is this a standard nes light gun? I have about five nes light guns (both the gray and the orange) and they all just have standard screws in them. If yours has security screws, it might be cheaper to buy an old one from ebay or a second hand store that has standard screws...

Crazy Cooter:
Mine is 100% original.  I got it from the guy that bought the vs machine new.  I don't need to take it apart yet, but I figured I could get a pic of what is needed for the original poster.  If you have regular screws, I'd say your guns have all been tuned up at some point.

The only problem I've had is that I have to let the monitor warm up for about 3-5 minutes for the shots to register accurately.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version