Main > Main Forum
How do y'all deal with games that require a separate coin slot/button for P2?
_) (V) (-):
Couldn't you just connect 2 wires to a single 'credit' switch?
Then when you put in a quarter or pressed the credit button, the switch would just trigger both wires, one each for the 5 & 6 keyboard mappings.
I'd think the single player games would end up getting 2 credits for each button press, but so what?
Tiger-Heli:
--- Quote from: CykoMF on September 18, 2006, 12:38:04 pm ---I'd think the single player games would end up getting 2 credits for each button press, but so what?
--- End quote ---
See reply #18.
yugffuts:
My cab has 4 coin slot's. It was originally a TMNT. I put 4 buttons on my panel, on the front panel for coins. So, if the crappy pic below is a SIDE view of my control panel, I have 1 buttons below each of the 4 players on the panel, where the X is. This is designed so the buttons are below the panel overhang if it is flipped open. Works great, and the buttons do not "clutter" the CP.
---------
|
|X
|
Tiger-Heli:
--- Quote from: yugffuts on September 18, 2006, 01:17:35 pm ---This is designed so the buttons are below the panel overhang if it is flipped open. Works great, and the buttons do not "clutter" the CP.
--- End quote ---
Another alternative I like is to wire the buttons to the coin reject switches.
yugffuts:
Yea, my panel is still "preliminary", but fully functional. When I finalize the design, and recut & finish the panel properly, I plan to wire to the coin slots. But for now it's working, and sometimes working=finished.
The way I have it now would work for someone with only 2 coin slots, though.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version