Main > Main Forum

Its been a while since i've been here. New project idea.

<< < (5/5)

Grasshopper:

--- Quote from: oldsage ---
I see... So did you just connect the switches to the jumpers on your I-PAC?
 

--- End quote ---

Yes.

I believe the newer Ipacs are jumperless so if I did this again two of the switches would not be needed. I'd also use a Minipac as it was a tight squeeze fitting a standard Ipac into the box.

The newer Ipacs autodetect between USB and ps/2 which is a useful improvement. But it's a shame that the facility to switch from a default to a programmable codeset has been removed

oldsage:

--- Quote from: Grasshopper on March 29, 2005, 06:58:47 am ---
--- Quote from: oldsage ---
I see... So did you just connect the switches to the jumpers on your I-PAC?
 

--- End quote ---

Yes.

I believe the newer Ipacs are jumperless so if I did this again two of the switches would not be needed. I'd also use a Minipac as it was a tight squeeze fitting a standard Ipac into the box.

The newer Ipacs autodetect between USB and ps/2 which is a useful improvement. But it's a shame that the facility to switch from a default to a programmable codeset has been removed

--- End quote ---

Sweet... Did you solder directly to the pins? It would be a shame to do something so permanent...
Also, are you sure about the new ones not having all those jumpers? It seems the one i bought a week ago does have a few jumpers on it... I hate jumpers... Never quite got the hang of them... :)

Anyway, sweeeeeet... Do you have a website documenting every little bit of what you did?

Navigation

[0] Message Index

[*] Previous page

Go to full version