Main > Main Forum
Coin Controls - Coin Mechs - Installation
DreamWeb:
Hey folks.
I'm just about done collecting the pieces for my cabinet (in fact.. this is the last bit)
My question is..
Can I pretty much choose any pair of coin mechs that I see on Ebay and have them fit my current coin door? How exactly do they fit in there? I take it they're pretty much universal?
Here's a shot of my coin door.
Thanks guys.
David
cholin:
Last time I checked, as long as they fit right, they should be OK. You may buy one that doesnt quite work the same, and may need a little hack, but I read that if they fit, they fit :P
DreamWeb:
A hack? That's what scares me!!
d.
cholin:
Haha nah not that bad, just like maybe tightenning a screw or crimping wires...nothing big.
Stingray:
Looks like a Coin Controls over/under. Standard mechs fit fine. Once you have the mech in hand it will be pretty obvious how they fit in there.
-S
Navigation
[0] Message Index
[#] Next page
Go to full version