Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: wiring monitor to jamma harness  (Read 1392 times)

0 Members and 1 Guest are viewing this topic.

cornbread

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 18
  • Last login:August 04, 2005, 07:21:34 pm
  • I want to build my own arcade controls!
wiring monitor to jamma harness
« on: March 19, 2005, 06:03:20 pm »
I am wiring a vision pro to a jamma harness.  I was told to connect the red green blue ground and sync wires to the jamma harness.  What are the sync wires and what position in the jamma harness do I connect these too? ???
Logged

tom61

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 495
  • Last login:September 18, 2017, 12:46:56 am
Re: wiring monitor to jamma harness
« Reply #1 on: March 20, 2005, 06:03:46 pm »
http://www.dameon.net/BBBB/jh.html <- About the Jamma Harness
You need to take a look at your monitor's manual and find the negative composite sync, that is the sync wire you want (typically wired with gray wire).
Logged
Pages: [1]
  
Go Up
« previous next »