Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: Applying full cabinet side art  (Read 1456 times)

0 Members and 1 Guest are viewing this topic.

Pipercub

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 206
  • Last login:December 08, 2009, 10:59:48 pm
  • My living room is a F'n arcade
    • Subaru Brat
Applying full cabinet side art
« on: December 02, 2005, 07:35:36 am »
I have done about a dozen side arts so I have pleanty of practice in getting them centered and bubble free. But to date I have never applied a full side decal that covers the entire side of the machine and has to be trimmed to fit. In this case I am doing Centipede. Anyone have experience applying art that big?
Logged

MikeQ

  • Guest
  • Trade Count: (0)
Re: Applying full cabinet side art
« Reply #1 on: December 02, 2005, 10:15:50 am »
Is this sideart that you had printed?  If so, where did you get it done and what were the dimensions.  I'm looking for someone that can print something 30"x54". 

As far as your question:  I plan on having the art printed slightly larger than the panel.  Apply the art on the panel with some overhang and then VERY carefully go back with a razor and trim off the overhang.
Logged
Pages: [1]
  
Go Up
« previous next »