Main > Main Forum
Drilling template for my coin door?
Ghoward:
You don't need a template just measure the inside edge of the door where the hole needs to be and draw the measurements on the front of your cab.
Next take a small paint can or food can and use it to draw the rounded corners of the door.
Place the door over the shape and make sure it's outside the lip of the covers the hole you are going to cut out.
Cut the hole out and fit the coin door if the corners are tight use a rotary tool to sand them down a bit.
Thats it.
Gary
gregor7777:
Ghoward has it.
Remember also that as long as it fits it doesn't even need to be perfectly precise as the front overlaps and covers the hole by quite a bit.
Navigation
[0] Message Index
[*] Previous page
Go to full version