Author Topic: JAMMA video connections (Read 1085 times)

Divergcm2 · « **on:** March 28, 2004, 09:39:37 pm »

I have refurbished a JAMMA cabinet and put a 6 in 1 card in it. The wire from the JAMMA harness to the video connector are very brittle and are starting to break. Is there a place to just buy the new video connectors with wire and solder them into the JAMMA harness, try to get the little wires back into the clip that goes into the chassis is a pain.

Any help would be appreciated.

Mike

menace · « **Reply #1 on:** March 28, 2004, 10:10:02 pm »

If I understand you right--just go to radioshack or some place similar and buy the right sized molex connectors--do some cut and splice action and you should be good to go.

Ken Layton · « **Reply #2 on:** March 28, 2004, 11:38:54 pm »

I believe Bob Roberts has Jamma video cables with the connector, pins, wires, already assembled for you.


Main	Restorations	Software	Audio/Jukebox/MP3	Everything Else	Buy/Sell/Trade
Project Announcements	Monitor/Video	GroovyMAME	Merit/JVL Touchscreen	Meet Up	Retail Vendors
Driving & Racing	Woodworking	Software Support Forums	Consoles	Project Arcade	Reviews
Automated Projects	Artwork	Frontend Support Forums	Pinball	Forum Discussion	Old Boards
Raspberry Pi & Dev Board	controls.dat	Linux	Miscellaneous Arcade	Wiki Discussion	Old Archives
Lightguns	Arcade1Up	Try the site in https mode		Site News


Unread posts \| New Replies \| Recent posts \| Rules \| Chatroom \| Wiki \| File Repository \| RSS \| Submit news

Author Topic: JAMMA video connections (Read 1085 times)

Divergcm2

JAMMA video connections

menace

Re:JAMMA video connections

Ken Layton

Re:JAMMA video connections