Is there any good original OG Xbox controller break out boards available?

[Customcade]

What's everyone's go to for original Xbox controller breakout encoders?

I took the guts out of the Sony SCPH-1110 dual joystick and want to put a controller board in it that works on the Xbox.

I originally stuffed a hard wired original controller S PCB strait up in it and it worked like a champ but it took me some time doing it all manual and custom.

All I can say is you never played Mech assault proper until you have played it on one of my setups 😎

[PL1]

I took the guts out of the Sony SCPH-1110 dual joystick and want to put a controller board in it that works on the Xbox.

Based on a few pictures of the guts of that controller, it will be easy to connect to the potentiometers, but tapping into the buttons on the PCB might be tricky.   

If you want to try an Arduino-based encoder, check out either Bruno's XBOXPadMicro . . .
http://forum.arcadecontrols.com/index.php/topic,152687.0.html
. . . the XInput version of the firmware for the Micro . . .
http://forum.arcadecontrols.com/index.php/topic,152687.msg1634808.html#msg1634808
. . . imp's XInput version of the firmware for Pro Micro . . .
http://forum.arcadecontrols.com/index.php/topic,152687.msg1674092.html#msg1674092

. . .  or Bruno's KADE miniArcade 2.0.
http://forum.arcadecontrols.com/index.php/topic,154126.0.html

XBOXPadMicro:
- Tested working and documented with the Arduino Micro or Pro Micro.
- Has several XInput firmware versions.
- Have to edit source and compile to customize pin/port assignments.

KADE miniArcade 2.0:
- Tested working and documented with many more 32u4 boards.
- Has no XInput firmware versions.
- Don't have to edit source and compile to customize pin/port assignments.


Scott