Arcade Collecting > Merit/JVL Touchscreen

megatouch sapphire kernal error help

<< < (3/9) > >>

wasted wages:
Tried both ways 3 on then flip 7 did nothing tried 8 nothing. Tried a few other combos still did nothing  was worth a shot Theo  :dunno

ed12:
well it was worth the shot..
ya your drive has gone south
just be careful with your flea-bay money
if the drive is to be shipped,because of there age make sure to request foam packing
or such to take the shock

ed

lilshawn:

--- Quote from: ed12 on September 14, 2014, 11:14:14 pm ---shawn is under snow right now
--- End quote ---

 :lol

not bad today... supposed to be 25 again. Weather can't make up it's damn mind.

that drive is long overdue for toast. heck, i have drives 5 years newer that are crapped out. I'm surprised it lasted as long as it has.

you will need to obtain another drive. word round the campfire is when they went from maxx to force, they just copied the same software and have it detect if it's maxx or force and display the appropriate splash screens.

wasted wages:
Ok finally got time to mess with my game a little more got the new hard drive. Still has the same error now what ?? :banghead:

mahkeymike:

--- Quote from: wasted wages on September 27, 2014, 05:20:04 pm ---Ok finally got time to mess with my game a little more got the new hard drive. Still has the same error now what ?? :banghead:

--- End quote ---

If its not the hard drive (which im surprised) Then it must be a setting in the bios. Like i have mentioned, I do not have maxx mobo so you will need to wait for ed or shawn to chime in here.

Only other suggestion, or test i would do to really narrow down the problem would be to connect the hard drive, touchscreen, and IO board to a working computer. If everything is working it would  load init and start running scripts. Then would probably go to a blank screen or a error screen because it detects the mobo is not the one its looking for.

One thing i can say is these old motherboards are very picky when it comes to newer or older hardware. I have a i810 mobo that for some reason will not boot a CF card attached to a CF to IDE adapter. I have force software loaded on this CF card and it boots fine with a few other i810 mobo's. It just wont boot on this one for some reason.

I have another that boots it for a few seconds but all the text is jumbled. Very strange issues that make no sense.

Navigation

[0] Message Index

[#] Next page

[*] Previous page