Arcade Collecting > Merit/JVL Touchscreen
Trying to power up a Megatouch motherboard
ed12:
that is a specific slot for the :hybryd-board's:
no foul done
best the op can do is chk like i asked them to
a sure sign the board is getting power is the fan's booting for a sec.
a=try soft booting >there is a set of pin's that allow for this<
b=power board up,and as shawn said meter the reg's
ed
gio_aus:
ed how would i perform the soft boot?
Sarver Systems:
on the board, there is a set of pins that you can short out with a small screw driver. Normally a pushbutton would be attached to these pins (when used as a PC inside of a PC case). SOmetimes the pins are marked, sometimes they aren't. If they ARE marked, they'll be marked as "PWR BTN", or maybe just "PWR". You'll see it near "RST" and "HD LED" and "PWR LED".
mahkeymike:
--- Quote from: gio_aus on June 10, 2014, 03:36:21 am ---ed how would i perform the soft boot?
--- End quote ---
By touching one of these sets of pins i marked in the picture you provided.
gio_aus:
ive tried touching the PWR SW pins and had no luck. Just tried the PWR pins and that didn't do anything either. Any other solutions? The power supply is powering up the pc it came out of without any problems, someone suggested it may be the ATX to AT adapter I'm using?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version