Main > Retail vendors
CNC Cut Bartop Kits - Orders Open! New Models Available!
HaRuMaN:
--- Quote from: macattack on March 19, 2013, 05:17:54 pm ---Pretty tight on those plans, not so bad if he is laser cutting, but routing even with a 1/8" bit is going to be tough without a vacuum bed. There is little to no room for tabs to hold parts in place. That said if he's got a vac bed no problem ;)
www. Xtremepinball.com
--- End quote ---
He has a 3-phase power CNC rig with a 18HP vacuum bed. It's quite impressive.
yotsuya:
--- Quote from: macattack on March 19, 2013, 05:17:54 pm ---Pretty tight on those plans, not so bad if he is laser cutting, but routing even with a 1/8" bit is going to be tough without a vacuum bed. There is little to no room for tabs to hold parts in place. That said if he's got a vac bed no problem ;)
www. Xtremepinball.com
--- End quote ---
I've seen the guy's setup. Not an issue! :cheers:
BadKarma:
Haruman, I am very interested in one of your weecades but I can not PM you, as I have just joined the site. Could you please shoot me an email and I will reply with the required information?
blaine.lippe@gmail.com
HaRuMaN:
--- Quote from: BadKarma on March 23, 2013, 06:50:47 am ---Haruman, I am very interested in one of your weecades but I can not PM you, as I have just joined the site. Could you please shoot me an email and I will reply with the required information?
blaine.lippe@gmail.com
--- End quote ---
Email sent!
ArcadeNerd:
Any word on the ones you were going to get this week?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version