Main > Retail vendors
CNC Cut Bartop Kits - Orders Open! New Models Available!
SNAAKE:
yes I may be in the market for a kit. you can customize the controls tho? not a fan of 8 buttons setup. its too cluttered and generally is useless. 6 button is good enough. I will send you a note if/when I am ready to place an order and discuss further business :burgerking:
HaRuMaN:
--- Quote from: SNAAKE on March 18, 2013, 06:19:46 pm ---yes I may be in the market for a kit. you can customize the controls tho? not a fan of 8 buttons setup. its too cluttered and generally is useless. 6 button is good enough. I will send you a note if/when I am ready to place an order and discuss further business :burgerking:
--- End quote ---
Sure can. :cheers:
HaRuMaN:
--- Quote from: HaRuMaN on March 18, 2013, 07:50:14 pm ---
--- Quote from: SNAAKE on March 18, 2013, 06:19:46 pm ---yes I may be in the market for a kit. you can customize the controls tho? not a fan of 8 buttons setup. its too cluttered and generally is useless. 6 button is good enough. I will send you a note if/when I am ready to place an order and discuss further business :burgerking:
--- End quote ---
Sure can. :cheers:
--- End quote ---
8 buttons dropped in favor of 6 buttons:
HaRuMaN:
If anyone else is interested in the wide kit shown above, let me know. It's based around this monitor:
http://www.amazon.com/ASUS-VH236H-23-Inch-Full-HD-Monitor/dp/B002453K5G
macattack:
Pretty tight on those plans, not so bad if he is laser cutting, but routing even with a 1/8" bit is going to be tough without a vacuum bed. There is little to no room for tabs to hold parts in place. That said if he's got a vac bed no problem ;)
www. Xtremepinball.com
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version