Main > Main Forum

Noob looking for some help hooking up ledwiz to buttons.

<< < (3/3)

briscos horse:
Thanks everyone!

Part of the problem was the buttons with built in LEDs that I am using are 12v.
The led wiz driven by the USB is 5v.
I wired up a bunch of batteries equaling 12v and the led worked fine.
I know I could also get 12v from a power supply but I am using a laptop to run my machine so I will just order 5v LEDs and then everything will be fine.

Thanks again

PL1:

--- Quote from: briscos horse on February 07, 2013, 11:53:44 am ---Part of the problem was the buttons with built in LEDs that I am using are 12v.
The led wiz driven by the USB is 5v.

--- End quote ---

The LED pic above is a 12v LED driven by USB 5v.

I've lit up 14 LED buttons and a trackball lighting circuit without a problem using USB 5v.

Bonus: This setup only draws ~81 mA. since I added an extra current limiting resistor.


Scott

briscos horse:
After seeing your post I just hooked up 6v batteries and it lit!!

When I get home after work I will try my ledwiz again.

briscos horse:
I finally got the leds working!
I wasn't able to hook them up to the banks on the led wiz because when i did they wouldnt light up. So for now only solid lights are working.
I guess more testing is needed or i need a voltmeter.

So far here is the progress:

Navigation

[0] Message Index

[*] Previous page

Go to full version