Main > Main Forum
Noob looking for some help hooking up ledwiz to buttons.
briscos horse:
I have a few BLUE CONVEX LED LIGHTED ARCADE PUSHBUTTONS
From Paradisearcade and I would like to connect hem to the Ledwiz.
I have looked all over and I have not been ble to find simple instructions.
The LEDs have 2 connectors.
Where do they go?
Does one go to the led wiz if so which one and where?
I have started trial and error but I don't want to fry the board or LED.
Thank you
Furry131:
http://groovygamegear.com/PDF/LEDWIZ_INSTALL.pdf
this should answer a bunch of your questions.
briscos horse:
I used that doc to hook up the first led I tried and it did not light up.
Not sure if I need to running the software on the pc that is connected to it before trying to make it light?
Thanks
RandyT:
--- Quote from: briscos horse on February 05, 2013, 03:46:22 pm ---I used that doc to hook up the first led I tried and it did not light up.
Not sure if I need to running the software on the pc that is connected to it before trying to make it light?
--- End quote ---
Yes, that is what will be controlling the LED. You can test the connection by holding a wire against the metal USB shell, and touching the terminal screw. If it lights like that, then it will light for your software.
briscos horse:
I installed the led wiz software the led didnt light up. There are 2 wires coming from the led which on do i touch the usb shell with? Also which terminal screw do i use for the other one?
Navigation
[0] Message Index
[#] Next page
Go to full version